• 2poles(Alminum poles with leveler, tips coated with chrome finish.)
• 1string
• 6beads(2 extra)
• 2custom-made pole bases

Graphite Design Putting Guide
Eagle USA $49.99

• 1Cut both strings to a desired length. Make sure both strings are cut the same length.
• 2Slide-in and tie up the beads on one-side of string.
• 3Insert each string into the top an botton hole of each pole.
• 4Connect the other end of each string with the beads. Make sure both strings are connected with equal length.(important)

• 1Insert two poles in the ground. Make sure each string is tensioned correctly. Check for crossing and loosening of strings.(Using on carpet or putting mat is recommended)

• 2Use the leveler to do the final adjustment of the pole. Air bubble in the leveler should come right in the Center of red-printed circle.

• 1After the poles are setup, make sure your shoulders, knees and feet are parallel to the strings. This is the basic form for putting.

• 2Put the golf ball right below your left eye. if you see one string from the top, that means you have correct putting form.(If you see two strings, it is incorrect)

• 3Check for putter face angle The face and strings should became perpendicular to each other. You should seeing only one string before and after the stroke.

• 4Once you start using the PUTTING GUIDE, you will strike the ball squarely and not "PUSH" or "PULL" the putt. You will line your putts perfectly.